Satellite Internet forum
https://www.satsig.net/cgi-bin/yabb/YaBB.pl
VSAT technology and installation >> Dish pointing and alignment >> Transmit carrier frequency offset
https://www.satsig.net/cgi-bin/yabb/YaBB.pl?num=1232729370

Message started by DELPHINE on Jan 23rd, 2009 at 4:49pm

Title: Transmit carrier frequency offset
Post by DELPHINE on Jan 23rd, 2009 at 4:49pm
Hi all,

We operate a SCPC link on NSS10. Since 2 weeks, we are facing with frequency offset on the transmit carrier from one side. The other side is stable. This offset is variable from 0, 8 kHz up to 12 kHz, but it makes the remote modem unclocked. Moreover, when the offset happens the carrier level goes lower.
Equipment used are P300 modem, Anasat Transceiver.

If someone has an idea on possible causes, could you please let me know ?

Many thanks,
Delphine

Title: Re: Transmit carrier frequency offset
Post by Eric Johnston on Jan 24th, 2009 at 4:25pm
Does the modem or transceiver show any alarms ?

Some guesses: TX LO PLL synth fault, overheating due to fan failure, power supply problems.

The P300 modem manual is here:
https://www.ironlinkus.com/ironlink/manuals/docs/Modems/Paradise/P3x0h.pdf (3.5 Mbytes pdf file)

The Anacom manual is here https://www.anacominc.com/Anasat_Ku_Band_Rev4.pdf (3.8 Mbytes pdf file) and it shows how to access status information for the TX Offset and TX synth oscillators, also the power supply voltages are shown.

If you are getting exact jumps of 0, 8kHz, 12 kHz I would suspect a PLL fault in the modem as that is intended to work with small frequency steps.  The Anacom goes in large 1 MHz steps.

Note that the Anacom unit uses single 10 MHz crystal reference so it would be worth checking the receive frequency also.

For a PLL fault, a possible workaround would be to try changing the Anacom by 1 MHz (or 2 MHz or 3 MHz etc)  and the modem an equal amount the other way.  That way you may get to use different pins on the PLL chips and might, with luck, avoid a dry joint.  With patience you can try tuning to a number of frequencies and looking to see if any are missing or not as commanded.

It is temperature related?
Does cycling the power on the modem fix the problem?
Does cycling the power on the Anacom fix the problem?
Try to isolate which part is causing the fault.  

While you have this symptom, tell the satellite operator and look at the whole output spectrum at the Anacom output in case the synthesisers are generating a spurious carrier and interfering with another service on the satellite.  It is very embarassing if when you type some specific digit in the frequency number it makes a wrong frequency carrier appear spaced well away across the band !

Best regards, Eric.

Powered by YaBB 2.5.2!
YaBB Forum Software © 2000-. All Rights Reserved.