Satellite Internet forum | |
https://www.satsig.net/cgi-bin/yabb/YaBB.pl
VSAT technology and installation >> iDirect Forum: hubs and terminals >> Video over IP with iDirect 3000 https://www.satsig.net/cgi-bin/yabb/YaBB.pl?num=1243921091 Message started by davidk on Jun 2nd, 2009 at 6:38am |
Title: Video over IP with iDirect 3000 Post by davidk on Jun 2nd, 2009 at 6:38am
Hi,
I have a unit of iDirect 3000 and I wish to configure it as a V(ideo)oIP application using a L-band signalv(DVB-S). Can you pls advise me how I can do that? Is there any firmware that I need to download onto the unit with iSite software for this application to work? In addition, if you have any document(s) describing this set up, I would appreciate if you could send it along with your reply. Thanks. |
Title: Re: Video over IP with iDirect 3000 Post by TDMAMike on Jun 2nd, 2009 at 12:16pm
David,
I dont think what you are describing is possible in an iDirect environment. I have never heard of anyone doing it. Why not buy an H.264/MPEG4P10 encoder/decoder and run your Video over IP? There are software or hardware versions are on the market, that fit this need. Also, you are using a 3000 series modem. It is not an eVOLUTION line modem and therefore does not support DVBS2. You have an iNFINITI board that does not support the DVB standard. Either way, I dont recommend that you load any software on tht iDirect board as its duty cycle is already busy enough (performing its satellite functionality). |
Title: Re: Video over IP with iDirect 3000 Post by davidk on Jun 3rd, 2009 at 7:41am
Thanks, Mike for your reply.
Regards; David |
Powered by YaBB 2.5.2! YaBB Forum Software © 2000-. All Rights Reserved. |