Satellite Internet forum | |
https://www.satsig.net/cgi-bin/yabb/YaBB.pl
VSAT technology and installation >> Dish pointing and alignment >> Beacon Signal https://www.satsig.net/cgi-bin/yabb/YaBB.pl?num=1258101477 Message started by okdesokdes on Nov 13th, 2009 at 8:37am |
Title: Beacon Signal Post by okdesokdes on Nov 13th, 2009 at 8:37am
1.2 parabolic antenna
LO:10.000 MHZ Ku-Band PLL LNB Satellite Beacon frequency:11.105.000 H 3430-L-2 Beacon Receiver I can't see beacon signal level in beacon receiver. Is there anyone who has any idea about this? Regards. |
Title: Re: Beacon Signal Post by Eric Johnston on Nov 13th, 2009 at 9:09am
Have you tuned the beacon receiver to the correct frequency ? (1105 MHz) ?
Have you set the receive polarisation to Horizontal and then applied the correct adjustment angle ? Are you pointed at the satellite ? Can you see the beacon using a spectrum analyser with a narrow resolution bandwidth ? If the PLL LNB needs an external 10 MHz reference, are you supplying a 10 MHz reference ? Best regards, Eric. |
Powered by YaBB 2.5.2! YaBB Forum Software © 2000-. All Rights Reserved. |