Satellite Internet forum | |
https://www.satsig.net/cgi-bin/yabb/YaBB.pl
VSAT technology and installation >> iDirect Forum: hubs and terminals >> GRE Tunnels https://www.satsig.net/cgi-bin/yabb/YaBB.pl?num=1263976157 Message started by prince on Jan 20th, 2010 at 8:29am |
Title: GRE Tunnels Post by prince on Jan 20th, 2010 at 8:29am
Dear All,
how can i establish GRE tunneling in remote 3100. i need the procedure sets up the GRE tunnel within the iDS system. how can i establish the actual GRE endpoints on both sides of the link for a GRE tunnel to work. how can i configure upstream from the Protocol Processor and downstream from the remote |
Title: Re: GRE Tunnels Post by TDMAMike on Jan 20th, 2010 at 11:27am
Talk to your hub operator.
|
Title: Re: GRE Tunnels Post by prince on Jan 20th, 2010 at 2:39pm
Just i want now wich ip will the hub getway.
|
Title: Re: GRE Tunnels Post by dot on Jan 20th, 2010 at 3:05pm
The iDirect equipment is GRE-aware. You need to create your GRE tunnel between a Cisco router or other device at the remote site and a device at the datacenter or near the hub. You then configure the IP addresses of these two end points of the tunnel in iBuilder. The iDirect platform will then accelerate all the traffic within this tunnel. The iDirect equipment cannot create or terminate a GRE tunnel. For more info read the iBuilder User Guide.
|
Powered by YaBB 2.5.2! YaBB Forum Software © 2000-. All Rights Reserved. |