Satellite Internet forum

Satellite Internet forum
https://www.satsig.net/cgi-bin/yabb/YaBB.pl VSAT technology and installation >> iDirect Forum: hubs and terminals >> Modem failed to activate (remained grey) https://www.satsig.net/cgi-bin/yabb/YaBB.pl?num=1299166771 Message started by angelkola on Mar 3^rd, 2011 at 3:39pm

Title: Modem failed to activate (remained grey)
Post by angelkola on Mar 3^rd, 2011 at 3:39pm

Hi House,
Kindly help wiv the issue i experienced here...an X3 site remained grey after installation on iDx 2.0. Both the remote status and UCP infos were observed on the iMonitor.

How do i go about it

Title: Re: Modem failed to activate (remained grey)
Post by Scout on Mar 3^rd, 2011 at 5:13pm

in iBuilder go to the remote and retrieve active configuration.
If the modem is online, UCP etc then the NMS should be able to recognize that after you retrieve active remote side.
If you are not able to retrieve the configuration, double check all IP configs in remote and in NMS for the remote, make sure no changes have been made since applying remote config.