Satellite Internet forum | |
https://www.satsig.net/cgi-bin/yabb/YaBB.pl
VSAT technology and installation >> iDirect Forum: hubs and terminals >> iscpc route configuration on idirect 5100 https://www.satsig.net/cgi-bin/yabb/YaBB.pl?num=1314422943 Message started by aniams on Aug 27th, 2011 at 6:29am |
Title: iscpc route configuration on idirect 5100 Post by aniams on Aug 27th, 2011 at 6:29am
Hello
Need some help in configuring packet routing between two remotes 5100 idirect modem. My ip plan is as follows: remote A sat0: 192.168.0.1/24 eth0:10.0.0.1/24 remote B: sat0: 192.168.0.2/24 eth0: 10.0.1.1/24 both sites have lock on the modem. I just need to start communication between them. regards |
Title: Re: iscpc route configuration on idirect 5100 Post by Andrew on Sep 21st, 2011 at 1:59am
Hi Aniams,
is it not connect to internet ? only 2 remote communication? if not then you can configure the routing from iSite. click edit, then add "static routes" from remote A : IP address : 10.0.1.0 subnet : 255.255.255.0 gateway : 192.168.0.2 interface : sat0 from remote B : IP address : 10.0.0.0 subnet : 255.255.255.0 gateway : 192.168.0.1 interface sat0 in case if you connect to internet you need to modify the routes table. |
Title: Re: iscpc route configuration on idirect 5100 Post by zizo9227 on Oct 12th, 2011 at 7:45am
another vaild way also is to enable RIPv2 on both interfaces (for both modems) from iSite without defining static routes but for sure this for LAN to LAN communication but when it comes to internet connectivity insertion of puplic IPs or NAT may be imperative.
|
Title: Re: iscpc route configuration on idirect 5100 Post by zizo9227 on Oct 12th, 2011 at 7:51am
With regard to the same topic, any idea about the typical QoS configuration for both ends of the link. Kindly elaborate.
|
Powered by YaBB 2.5.2! YaBB Forum Software © 2000-. All Rights Reserved. |