Satellite Internet forum | |
https://www.satsig.net/cgi-bin/yabb/YaBB.pl
VSAT technology and installation >> Dish pointing and alignment >> problem in receive data carrier https://www.satsig.net/cgi-bin/yabb/YaBB.pl?num=1316341941 Message started by Mohammed32 on Sep 18th, 2011 at 11:32am |
Title: problem in receive data carrier Post by Mohammed32 on Sep 18th, 2011 at 11:32am
Hello
I got a question if you could help pls i have to re-point the"2.4m" c band dish i work on from NSS7 22 w to NSS 5 20 w,which i did that days ago but the problem was the modem couldn't lock on the data carrier i should receive i checked every thing the dish align the cables the pols the 12v dc to the LNB all was fine i can see the other carriers on the spectrum not the one i want to receive the Satellite control can see the data carrier i should receive but i cant, they can see me when i transmit CW carrier and with very clean signal no side lope and when modulate the carrier. when i go back to NSS7 i can receive just fine with the same setting(modem,LNB,cables, and connectors). i have to do that again soon can you think of any thing that i have missed. |
Title: Re: problem in receive data carrier Post by USN - Retired on Sep 18th, 2011 at 12:34pm
Received your IMs, will respond to the best of my ability here. Given the info provided, I can only make a few basic suggestions:
1. review new parameters with control station, re-verify same in equipment at both ends. 2. control station may not have recalculated link budget for new satellite parameters. I suggest you request of them the same as they asked of you; that is, have the control terminal put a CW carrier up in your assigned NSS5 slot 3. Get a second spectrum analyzer opinion. Not sure if it's available, but - given the correct parameters - the site owner (eric@satsig.net) may be able to help/ And it wouldn't hurt to read this: https://www.satsig.net/itu/c-band-spectrum.htm //greg// |
Powered by YaBB 2.5.2! YaBB Forum Software © 2000-. All Rights Reserved. |