Satellite Internet forum | |
https://www.satsig.net/cgi-bin/yabb/YaBB.pl
VSAT technology and installation >> iDirect Forum: hubs and terminals >> Remote Taking too long to acquire into the network https://www.satsig.net/cgi-bin/yabb/YaBB.pl?num=1336416354 Message started by dhrisht on May 7th, 2012 at 7:45pm |
Title: Remote Taking too long to acquire into the network Post by dhrisht on May 7th, 2012 at 7:45pm
Hello Team,
We have below network config: Outbound: Modulation: ACM Error Correction: LDPC BCH Symbol Rate: 144400 Ksym FEC Blocks per Frame: 1800 Frame Lenght: 125 ms Inbound: Modulation: QPSK Error Correction: 2D 16s-170bytes (3/4) Symbol Rate: 450 ksym Acquisition Aperture: 773 sym Traffic Slot: 57 On outbound, provider has given only 1024 Kbps. We have approx 73 remotes in the network but all remains down except 3 sites are up. Problem is that remote takes 8 to 10 minutes to acquire into the network. I would like to know how long remotes should take to acquire and how can i calculate? Thanks & Regard, Dhrisht |
Title: Re: Remote Taking too long to acquire into the net Post by SuperDave on May 8th, 2012 at 4:35pm
After the modem is fully booted up, you should see your modem begin aquisition after just a few sweeps, You will see a remote_hello cmd followed by power adjustments coming in from the Hub. Never actually timed it but it should be way less than 8 minutes (more like 2-3 minutes total - including boot process)
What model/type LNB's are you running? And are you sure the Geo's are good on the remotes that are not bursting into the net? |
Title: Re: Remote Taking too long to acquire into the net Post by Mohamed.Zein on May 9th, 2012 at 7:47am
what about initial and maximum power settings? may be it is causing the delay.
|
Title: Re: Remote Taking too long to acquire into the net Post by erico on May 12th, 2012 at 7:54pm
Hello,
Check also the GPS Position accuracy for the remote not acquiring quickly ... |
Title: Re: Remote Taking too long to acquire into the net Post by tunde300us on May 18th, 2012 at 2:40pm
Check also the firmware !
|
Powered by YaBB 2.5.2! YaBB Forum Software © 2000-. All Rights Reserved. |