Satellite Internet forum | |
https://www.satsig.net/cgi-bin/yabb/YaBB.pl
Service Providers >> TooWay and KA-SAT satellite >> Replace F-connector by BNC connector? https://www.satsig.net/cgi-bin/yabb/YaBB.pl?num=1410802617 Message started by le-bo2d9 on Sep 15th, 2014 at 6:36pm |
Title: Replace F-connector by BNC connector? Post by le-bo2d9 on Sep 15th, 2014 at 6:36pm
Hi,
I'm a new Tooway KaBand satellite user. I have a flyaway antenna build in in a flightcase. All equipment is build-in in the lid. The motor is fixed in the base of the fligtcase. Now I want to place connectors to the RF cable and the power cable. Here is my question can i use BNC connector to connect the RF cable instead of the F-connector. The connector I want to use in the flightcase is the Neutrik NBB75DFIB on the cable I will use the Neutrik NBNC75XXXX connector (still need to lookup the correct connector) Kind regards Kind Regards |
Title: Re: Replace F-connector by BNC connector? Post by Admin1 on Sep 15th, 2014 at 7:23pm
Consider using a "quick on f connector" adaptor. Look in Google/Amazon.
They are easily damaged so be careful in use. Lubricate centre pin with electronic grade silicone contact grease. Make sure external spring does not get lost. Get a few spares. Really important: Do not connect or disconnect with the power on. Note that the diameter of centre pin in f connectors is not standardised and does vary. If a larger diameter has been used before the socket springs may be stretched and if a new plug with thinner pin is applied the contact may be unreliable. Best regards, Eric |
Title: Re: Replace F-connector by BNC connector? Post by Alphaco on Jun 21st, 2015 at 9:49am
old thread, but I'd use BNC rather than the plug-on F-connector, which I only use on my sat finder scope, for reasons of much higher current to be delivered to the TRIA than to an LNB. N connector could even be better, but is hard to find in 75 ohm and a bit clunky.
|
Powered by YaBB 2.5.2! YaBB Forum Software © 2000-. All Rights Reserved. |