Satellite Internet forum
https://www.satsig.net/cgi-bin/yabb/YaBB.pl
VSAT technology and installation >> iDirect Forum: hubs and terminals >> can't assigned XLC-10 in Chassis 15001
https://www.satsig.net/cgi-bin/yabb/YaBB.pl?num=1411527004

Message started by Marcell1987 on Sep 24th, 2014 at 3:50am

Title: can't assigned XLC-10 in Chassis 15001
Post by Marcell1987 on Sep 24th, 2014 at 3:50am
I can't assigned XLC-10 in Chassis 15001. I have already lowered the speed from 1000 Mbps to 100 Mbps as required cause the type of the chassis.
What usually happen when linecard can't assign to chassis?
I can't ping to IP GIG0 (is that allowed?)
XLC-10_repair_test_satsig1.gif (56 KB | 259 )

Title: Re: can't assigned XLC-10 in Chassis 15001
Post by Mwafrika on Oct 5th, 2014 at 5:21am
Hello Marcel,
What is the serial number of the HLC?
Is there any error message?

Title: Re: can't assigned XLC-10 in Chassis 15001
Post by fluffymassive on Oct 8th, 2014 at 5:44am
what settings do you have for your switchport? auto? if so change it to 100mbps.

this is from the manual:

Under GIG0 IP Address:
a. Enter the IP address for downstream data from the protocol processor to the network.
b. Use the drop-down menu to set the Speed of your GIG0 port to 100 Mbps or 1000
Mbps.
Note: Your switch and chassis must support the selected port speed. (Older iDirect
chassis do not support 1000 Mbps.) Also, you must explicitly configure the port
speed on your switch to be the same as the port speed selected for the line
card. Do not set the switch to auto-negotiate.

Powered by YaBB 2.5.2!
YaBB Forum Software © 2000-. All Rights Reserved.