Home page of Satellite Internet and Information

Satellite Internet Forum.

Welcome, Guest.
Welcome to this satellite broadband discussion forum. Wherever you are and whatever your problem we are here to help each other. Connecting to the internet via satellite is not always easy but is critically important to those in remote places or with poor terrestrial infrastructure. Both service providers and customers are encouraged to contribute. Register at the bottom of the forum home page if you wish to contribute or ask question. Read the Forum rules.
      Satellite Internet Forum : Home Page          
Pages: 1

rx freq <val> active immediately or after re

(Read 1429 times)
Ex Member
Ex Member


Sep 18th, 2008 at 6:36pm  
if I issue

rx freq <value>

on an iDirect series 3000 satellite router, does the setting become active immediately or do I need to write to flash and reset?

thanks,

rob.
Back to top
 
 
IP Logged
 
Ex Member
Ex Member


Reply #1 - Sep 19th, 2008 at 12:26am  
When you plug an Lband frequency into an iDirect unit (through command line) it becomes effective immediately. That said, the unit will have to be rebooted to return to the original frequency plan specified in the options file (falcon).  

When you specify a freq via command line (tx or rx) it is stored in temp memory ONLY (hence the reason for the reboot - to clear it)

Back to top
« Last Edit: Sep 20th, 2008 at 2:57pm by N/A »  
 
IP Logged
 
Pages: 1