w3a satellite alignment

(Read 4663 times)

nanayawgh Member ★★ Offline Posts: 2	Feb 17^th, 2011 at 4:52pm Dear all, Please i need support to align my 1.8dish antenna to point Eutelsat W3A satellite using Strong SRT4669x decoder. please specify frequency and symbol rate i can use to pick signals. thanks nanayawgh
Back to top	IP Logged

Admin1

YaBB Admin
★★★★★
Offline

Posts: 1191

Reply #1 - Feb 17^th, 2011 at 7:58pm

Have a look in https://www.lyngsat.com/ew3a.html �find a W3A beam map that covers your area.
Note the frequency, symbol rate and polarisation name of a suitable TV carrier.

Assuming use of a common Universal Ku band Satellite TV LNBF, with switchable low/high freq band and switchable linear polarisation ...

Subtract your LNB local oscillator frequency (normally 9750 MHz or 10600 MHz, controlled by 22 kHz tone) and then tune your receiver to the appropriate L band frequency and set the 22 kHz tone off or on.

Polarisation. Start with your LNB upright. If you need to apply a positive adjustment turn the LNB clockwise by that amount while facing towards the satellite in the sky. �Use low/high (13V or 19 V) LNB voltage to select the alternative Vertical or Horizontal polarisation names.

Calculate the pointing angles and polarisation adjustment here https://www.satsig.net/maps/lat-long-finder.htm
wxw
Best regards, Eric.

« Last Edit: Feb 18^th, 2011 at 9:33am by Admin1 »

WWW

IP Logged

nanayawgh Member ★★ Offline Posts: 2	Reply #2 - Feb 18^th, 2011 at 6:45am Thanks Eric, i will be on site this morning to use your method. I will send you more feedback thanks best regards, Nanayawgh
Back to top	IP Logged

Pages: 1

Send Topic | Print

Disclaimer, Terms of Use and Privacy Forum User Agreement Forum rules Cookie policy.