Intelsat 12 Beacon CW Plot

(Read 3904 times)

akki

Member
★★
Offline

Posts: 25

May 30^th, 2012 at 8:00am

Hi,

We are trying to point our 1.2m KU Band antenna on Intelsat 12 at Beacon frequency 11697 V polarization. We are using Universal LNB with LO frequency 9.75, 10.60 GHZ on spectrum analyzer.

So our receive center frequency will be 1097 MHz on spectrum analyzer. Kindly can you send me plot of your beacon CW wave on Middle East beam so I can make sure that I am on right location and satellite.

IP Logged

Admin1

YaBB Admin
★★★★★
Offline

Posts: 1192

Reply #1 - May 30^th, 2012 at 10:11am

If you are using a DRO type Universal LNB (LO frequency 9.75 or 10.60 GHz) beware of frequency error and drift if you are trying to find a low level CW beacon signal. �The DRO in the LNB could be as much as 2 MHz in error. Read the LNB specification.

If you use the analyser with narrow span and narrow resolution bandwidth you may miss the beacon completely, but when you do see it it will be large and very clear.

If you use the analyser with a wider span and wider resolution bandwidth you may hardly be able to see the beacon, like a low lump in the noise floor.

A PLL type LNB is best if you are seeking low level CW carriers.

On IS-12, there may be another beacon at 11697.5 MHz.

Tell us what you see and what polarisation.

Best regards, Eric.

« Last Edit: May 30^th, 2012 at 1:39pm by Admin1 »

WWW

IP Logged

Pages: 1

Send Topic | Print

Disclaimer, Terms of Use and Privacy Forum User Agreement Forum rules Cookie policy.