Satellite Internet forum | |
https://www.satsig.net/cgi-bin/yabb/YaBB.pl
VSAT technology and installation >> LinkStar Forum: VSAT hubs and terminals >> Making Linkstar Unlock Cables https://www.satsig.net/cgi-bin/yabb/YaBB.pl?num=1105903419 Message started by priest on Jan 16th, 2005 at 8:23pm |
Title: Making Linkstar Unlock Cables Post by priest on Jan 16th, 2005 at 8:23pm
I need help to unlock a linkstar modem. I have located the serial port, but it is left to me to make the cable.
My questions are - 1. In making the cable is it the two ends that will be connectors? What does each end look like The folowing information is not explanatory enough "Only the middle 4 pins are used (use a 4 pin connector phone plug) Looking at the phone plug with the clip facing away from you. pin 1 goes to pin 5 on the serial connector pin 2 goes to pin 2 on the serial connector pin 3 goes to pin 3 on the serial connector pin 4 not used " WHAT IS THE LOOPBACK ABOUT? "some loopbacks on the serial connector 7 and 8 are looped 1 and 4 are looped 6 and 4 are looped" I will be very grateful if you can explain how to make the cable from 2 phone connectors and a 8wire network cable. I will be very happy if a quick response is given. |
Title: Re: Making Linkstar Unlock Cables Post by maliksat on Jan 16th, 2005 at 9:54pm
can u show me how i can located the serial port
|
Title: Re: Making Linkstar Unlock Cables Post by priest on Jan 17th, 2005 at 11:28am
The serial port is at the back of your PC. It is a 9-pin port where you usually put a mouse (if you are using a serial mouse).
|
Title: Re: Making Linkstar Unlock Cables Post by maliksat on Jan 18th, 2005 at 8:33am
thanks piest but i would know the serial port of the linkstar
|
Title: Re: Making Linkstar Unlock Cables Post by Rizal on Jan 4th, 2006 at 2:30am
If you are using the old Linkstar version, it does not show the serial/RJ11 port on the outside. Its inside the modem, but you 'll be voiding your warranty.
|
Powered by YaBB 2.5.2! YaBB Forum Software © 2000-. All Rights Reserved. |