Satellite Internet forum
https://www.satsig.net/cgi-bin/yabb/YaBB.pl
VSAT technology and installation >> LinkStar Forum: VSAT hubs and terminals >> lat and long
https://www.satsig.net/cgi-bin/yabb/YaBB.pl?num=1120469467

Message started by Ant._Mazzoleni on Jul 4th, 2005 at 11:31am

Title: lat and long
Post by Ant._Mazzoleni on Jul 4th, 2005 at 11:31am
For the first time, I have to set up a linkstar with telnet.
It's all ok, but i am not able to set latitude and longitude with SAVEBOOTPARMS -lat -lon. When i control the configuration with DBPR BOOTCONF latitude and longitude are always 0.
I'm sure to insert correct value, with converting degrees minutes seconds.
Could you help me?

Title: Re: lat and lon
Post by schak134 on Apr 19th, 2006 at 1:25pm
you need to enable the gps make this command save -m 1
then enter your lat and long

Title: Re: lat and long
Post by Eric Johnston on Jan 16th, 2007 at 3:25pm
If you need to know your latitude and longitude please try this page Lat - Long Finder.

It will also tell you the azimuth, elevation and polarisation angles for your satellite dish at the same time.  Select the satellite, then click progresssively on the map and magnify until you arrive at your site.

Best regards, Eric.

Powered by YaBB 2.5.2!
YaBB Forum Software © 2000-. All Rights Reserved.