| Satellite Internet forum | |
|
https://www.satsig.net/cgi-bin/yabb/YaBB.pl
VSAT technology and installation >> LinkStar Forum: VSAT hubs and terminals >> Can't see my Linkstar transmit https://www.satsig.net/cgi-bin/yabb/YaBB.pl?num=1168193040 Message started by mysatcompany on Jan 7th, 2007 at 6:04pm |
|
|
Title: Can't see my Linkstar transmit Post by mysatcompany on Jan 7th, 2007 at 6:04pm
My lSP can't me transmit. Everything is fine.
Modem locked on satellite. Cables good working condition. What is the command to reset linkstar to default configuration? Thanks. |
|
Title: Re: can't see mine transmit Post by Eric Johnston on Jan 7th, 2007 at 7:24pm
Check that you have put in the correct boot parameters.
see for example: https://www.link-sat.net/linkstar-command-pconf.htm Read every item and compare with the line you were given to type in. If you have rx= fast flashing green and have a BER like 0.0001, it is ready to be commissioned. Speak with the hub and they will send a message over the satellite to the LinkStar RSCT modem to start the process. wxw They may give you a special line to type in to do uplink cross-polarisation measurements. Get under the feed arm to make very small feed rotation adjustments if requested. The hub needs time to make each measurement, so be patient between each movement. Best regards, Eric. |
|
Title: Re: Can't see my Linkstar transmit Post by epsilon on Jun 1st, 2007 at 12:17am
Dont go so far, after testing PCR and cpid parameters and you still dont succeed, take a multimeter and measure -at the cable end entering into the buc- if you are receiving 15V and above voltage. If not, just check your RG6 connector, or even the buc
|
|
Powered by YaBB 2.5.2! YaBB Forum Software © 2000-. All Rights Reserved. |