Satellite Internet forum | |
https://www.satsig.net/cgi-bin/yabb/YaBB.pl
VSAT technology and installation >> Dish pointing and alignment >> Point dish at PAS 1R ? https://www.satsig.net/cgi-bin/yabb/YaBB.pl?num=1171468371 Message started by chaady on Feb 14th, 2007 at 3:52pm |
Title: Point dish at PAS 1R ? Post by chaady on Feb 14th, 2007 at 3:52pm
HOW TO POINT THE DISH TO PAS 1R IN LIBYA
AND WHAT IS EQUPMENT REQURIED TO GET SGNAL USING I DIRECT SYS |
Title: Re: PAS 1R Post by Eric Johnston on Feb 14th, 2007 at 4:24pm
Go to this page: https://www.satsig.net/maps/lat-long-finder.htm
Double click on Libya to put it in the middle. Select the wanted satellite PAS-1R at 45 west Then expand the scale ( + ) and select Hybrid image, till you can see your site. Write down the azimuth, elevation and polarisation required. On your dish, set the feed assembly rotation angle (polarisation) as follows: First set to the nominal downlink polarisation. What nominal polarisation have you been told ? If Horizontal then you need to turn the feed assembly so that the broad faces of the LNB waveguide are on either side. Second, while facing towards the satellite, rotate the feed assembly clockwise for positive polarisation angles. An inclinometer put sideways across the BUC helps set this angle accurately. There may be a tiny crude scale on the feed throat clamp. You can use this to measure the amount of movement required but ignore any +/- signs. On the back of your dish mount set the elevation angle. Swing the dish boldly in the general azimuth bearing direction and the iDirect RX should go green. Peak up. Best regards, Eric. |
Powered by YaBB 2.5.2! YaBB Forum Software © 2000-. All Rights Reserved. |