Satellite Internet forum | |
https://www.satsig.net/cgi-bin/yabb/YaBB.pl
VSAT technology and installation >> iDirect Forum: hubs and terminals >> iDirect 3100 console / Rx lock issue https://www.satsig.net/cgi-bin/yabb/YaBB.pl?num=1189457078 Message started by otnsat on Jul 18th, 2007 at 11:21am |
Title: iDirect 3100 console / Rx lock issue Post by otnsat on Jul 18th, 2007 at 11:21am
Hi all,
I have a strange issue concerning a 3100 series remote (running software version 6.0.9.4): I only achieve an Rx lock if I have an active Hyperterminal session to the remote. I cannot reset the modem via iMonitor. I've noticed that the value for Rx AGC is usually somewhere around -30 to -20. Without the Hyperterminal connection, this value is around +7. Once I connect to the remote via Hyperterminal, the Rx AGC value changes to -30 and the remote connects to the network. Does anyone know the reason and how to solve this? Thanks |
Title: Re: iDirect 3100 console / Rx lock issue Post by otnsat on Jul 25th, 2007 at 10:45am
Hi all,
the problem is solved. It was caused by the console cable used to configure the remote locally - it was faulty and thus caused the strange behaviour. Regards |
Title: Re: iDirect 3100 console / Rx lock issue Post by Y2J on Oct 3rd, 2007 at 8:36am
I have some problem to get connected to by console cable. The cable itself is tested and working fine. The modem I want to connect to is red-blinking the status LED, that's why I need to connect to it via console to check out the cause of the problem.
I hope anyone have an idea how to get connected to it ? Another Issue: I have a working iDirect 3000 working but sometimes it cant lock the rx signal and sometimes it needs a lot of time to do ( 2 - 3 mins). When I do the command: rx enable on It connected immediately! I think that if anyone have an idea if there's an parameter in the option file that help to make this command run by default ? Thanks in advance. |
Powered by YaBB 2.5.2! YaBB Forum Software © 2000-. All Rights Reserved. |