| Satellite Internet forum | |
|
https://www.satsig.net/cgi-bin/yabb/YaBB.pl
VSAT technology and installation >> iDirect Forum: hubs and terminals >> Can't hook iDirect 3000 to desktop https://www.satsig.net/cgi-bin/yabb/YaBB.pl?num=1189457548 Message started by Starex on May 9th, 2007 at 9:56pm |
|
|
Title: Can't hook iDirect 3000 to desktop Post by Starex on May 9th, 2007 at 9:56pm
Hi all ,
Can any one please help me with hook up my iDirect 3000 SAT router to my desktop ? My SAT router came with some special UTP cable that used to connect to my desktop fine. I've lost that cable and now I'm using a normal CAT 5e UTP cable , but when I connect it to my desktop ethernet LAN card (D-Link) it says "acquiring IP address and nothing will happen, even the light on the ethernet card does not go on. I've even tried to configure static IP address according to my provider setting and no luck with this also. The same cable works fine with my laptop. Can any one please tell me how to fix this, or what type of UTP cables was that one ? Thank you and regards |
|
Title: Re: Can't hook iDirect 3000 to desktop Post by scooterz56 on May 9th, 2007 at 11:18pm
If you are connected directly to the modem you will need a crossover cable instead of a standard cable.
If you don't have a crossover cable you can use a small hub and 2 standard cables. Hope this helps. |
|
Title: Re: Can't hook iDirect 3000 to desktop Post by Starex on May 14th, 2007 at 9:26am
Hi Scooterz,
The cross-over worked fine for me . Thank you very much ! regds, |
|
Powered by YaBB 2.5.2! YaBB Forum Software © 2000-. All Rights Reserved. |