Satellite Internet forum
https://www.satsig.net/cgi-bin/yabb/YaBB.pl
VSAT technology and installation >> Dish pointing and alignment >> dielectric plate material and circular Feed
https://www.satsig.net/cgi-bin/yabb/YaBB.pl?num=1199081137
Message started by boni_daandel on Dec 31st, 2007 at 6:05am

Title: dielectric plate material and circular Feed
Post by boni_daandel on Dec 31st, 2007 at 6:05am
Dear all,
i'm using an NSS 703 services at Indonesia Center java,
and we get the carier w a reguler 12 f mesh prime focus antenna, reguler feed w servo and c-band Norsat LNB 3xxx series.

this service is used for DVB Ip RX/downstream only services,  w 45000 Kbaud,  and RHCP polarity.

so far we put a dielectric plate on the feed  for change to Circular Pol. but now we dificult to find this material of Dielectric plate here.

can  anyone here give some advice, what kind of material that easy can find for replace with no reduce of quality.

and did we can made a simple c-band circular feed ?
any advice ?

thanks and regards

Boni-

Title: Re: dielectric plate material and circular Feed
Post by koke1234 on Feb 26th, 2008 at 1:27am
my friend it is very easy to to find this material you know the fiber glass that they do kitchens with so just find a small pice and you have to give it the same size that fit the feedhorn 3 cm by 5cm approximately  it will work as new.
best regards

Powered by YaBB 2.5.2!
YaBB Forum Software © 2000-. All Rights Reserved.