Satellite Internet forum | |
https://www.satsig.net/cgi-bin/yabb/YaBB.pl
VSAT technology and installation >> iDirect Forum: hubs and terminals >> GRE Tunnel iDirect 3100 to SDN Global https://www.satsig.net/cgi-bin/yabb/YaBB.pl?num=1219767463 Message started by swedishchef on Aug 26th, 2008 at 5:17pm |
Title: GRE Tunnel iDirect 3100 to SDN Global Post by swedishchef on Aug 26th, 2008 at 5:17pm
Hello All,
Just found and joined this board. I have had a few questions come to mind. After reading the documentation on iDirect It seems to me that it is possible to use the TCP acceleration on a GRE Tunnel. I have one built from a Cisco router to Cisco Router but am only getting about 80k throughput on a data transfer on a 256k uplink. That leads me to believe this is not happening. I called our provider and forwarded the documentation to set up GRE tunnel acceleration that I found myself. We are going to go to a VNO solution soon with me being one of the guys that get's to play with this technology. So, is this possible? Accd to this it is. And what else do I need my provider to do to accomodate us? https://www.idirect.net/libraries/cm_software_releases/iDirect%20Release%20Notes%206.0.6.pdf |
Title: Re: GRE Tunnel iDirect 3100 to SDN Global Post by TDMAMike on Aug 26th, 2008 at 6:13pm
Just be advised that the above procedure only sets up a GRE tunnel within the iDS. You will still be required to establish the actual endpoints on both sides of the link for the tunnel to work. Read: One GRE endpoint must be configured upstream from the protocol processor, the other downstream from the remote.
What flavor of acceleration are/were you using when you observed the 80kbps of BDP? |
Powered by YaBB 2.5.2! YaBB Forum Software © 2000-. All Rights Reserved. |