Satellite Internet forum
https://www.satsig.net/cgi-bin/yabb/YaBB.pl
VSAT technology and installation >> iDirect Forum: hubs and terminals >> PP CHARGE REBALANCY
https://www.satsig.net/cgi-bin/yabb/YaBB.pl?num=1224604110
Message started by LAKHDARIAHUB on Oct 21st, 2008 at 4:48pm

Title: PP CHARGE REBALANCY
Post by LAKHDARIAHUB on Oct 21st, 2008 at 4:48pm
dear all
How do I know that PP is working in load sharing (charge rebalncy) with other PPs and how to make it work charge rebalancy

Title: Re: PP CHARGE REBALANCY
Post by TDMAMike on Oct 21st, 2008 at 10:16pm
Are you asking how to rebalance the PPs?  Not sure what you are asking...

Title: Re: PP CHARGE REBALANCY
Post by TDMAMike on Oct 22nd, 2008 at 3:45am

LAKHDARIAHUB wrote on Oct 21st, 2008 at 4:48pm:
dear all
How do I know that PP is working in load sharing (charge rebalncy) with other PPs and how to make it work charge rebalancy

To determine balance: Right click the PP in iMonitor and select "Blade Info."  Once it appears in the pane, expand the remotes portion of the tree.  There should be an equal amount of remotes on each blade (or close to it).  If they are not equal then you probably need to rebalance them.  You can also check the utilizations on the boxes themselves to determine whether or not a rebalance is required.

As for commanding the rebalance, you have to grep the dynamic port that the pp_controller resides on.   Once you have it, you can telnet to the localhost (port#) and issue the command to rebalance.  Be advised: There will be a service interruption of 5-6 minutes for certain remotes as they are migrated to other blades.  So, this rebalance accordingly.

Powered by YaBB 2.5.2!
YaBB Forum Software © 2000-. All Rights Reserved.