Satellite Internet forum | |
https://www.satsig.net/cgi-bin/yabb/YaBB.pl
VSAT technology and installation >> LinkStar Forum: VSAT hubs and terminals >> switching from iDirect to Linkstar https://www.satsig.net/cgi-bin/yabb/YaBB.pl?num=1234739402 Message started by David H on Feb 15th, 2009 at 11:10pm |
Title: switching from iDirect to Linkstar Post by David H on Feb 15th, 2009 at 11:10pm
I've got a 2.4m dish that I use with iDirect service on Ku and C band. I use NJT BUCs and Norsat LNBs. If I switch over to a LinkStar service, will I need to change out the BUC and/or LNB?
-- David |
Title: Re: switching from iDirect to Linkstar Post by satnew on Feb 16th, 2009 at 10:52am
Find that out from your service provider for Linkstar. Give them the model of the BUC and LNB that you already have and they'll tell if those are within their RF range.
regards |
Title: Re: switching from iDirect to Linkstar Post by David H on Feb 16th, 2009 at 2:10pm
OK, I understand that. How about powering the BUC. Does the LinkStar modem do that in the same way that the iDirect modem does? If I read the specs correctly, it looks like the LinkStar can power up to a 5W BUC, just like the iDirect.
|
Title: Re: switching from iDirect to Linkstar Post by Oasis Networks on Feb 16th, 2009 at 7:12pm
Dear David,
The answer is yes, if your BUC was powered by the iDirect, the linkstar modem should be able to power it as well. |
Title: Re: switching from iDirect to Linkstar Post by David H on Feb 16th, 2009 at 9:06pm
Sounds good. Thanks for the replies.
|
Powered by YaBB 2.5.2! YaBB Forum Software © 2000-. All Rights Reserved. |