Satellite Internet forum

Satellite Internet forum
https://www.satsig.net/cgi-bin/yabb/YaBB.pl VSAT technology and installation >> iDirect Forum: hubs and terminals >> 3100 problem https://www.satsig.net/cgi-bin/yabb/YaBB.pl?num=1236331146 Message started by acil on Mar 6^th, 2009 at 9:19am

Title: 3100 problem
Post by acil on Mar 6^th, 2009 at 9:19am

Buc power led is red.
what can ı do?

Title: Re: 3100 problem
Post by dot on Mar 6^th, 2009 at 9:58am

Check your transmit cable, connectors, waterproofing, etc. Disconnect the transmit cable and power cycle the remote, if the LED remains red the remote is dead, RMA or buyy a new one. If not there is a short over over current somewhere towards the BUC.

Title: Re: 3100 problem
Post by TDMAMike on Mar 6^th, 2009 at 12:08pm

Red Tx is not healthy.

I would try the above, and if you have ethernet or console access to that box I would also try to re-image that unit.

Naturally, if it is a 3100 and you are using iDS 7.1.1 or better (7.1.X, 8.X, etc) dont forget to install the upgrade_prep pkg before you engage the BSP and image.

That may resolve it, but RED is normally indicative of a hardware failure of sorts.

M