Satellite Internet forum | |
https://www.satsig.net/cgi-bin/yabb/YaBB.pl
VSAT technology and installation >> iDirect Forum: hubs and terminals >> how to access remote x3 consol remotely? https://www.satsig.net/cgi-bin/yabb/YaBB.pl?num=1243164478 Message started by backtrack on May 24th, 2009 at 12:27pm |
Title: how to access remote x3 consol remotely? Post by backtrack on May 24th, 2009 at 12:27pm
hello guys again
as i know console connection to idirect modem need physical connection through lan port isthat right? can i establish console connection (idirect linux kernel) remotely? |
Title: Re: how to access remote x3 consol remotely? Post by TDMAMike on May 24th, 2009 at 1:56pm
Although I am not 100% certain, I think you must have a physical connection to that console interface.
Most Hub Operators/Owners use a Console Server, such as a Comtrol Device master RTS, etc to get at the console port remotely (line cards, etc). For a remote user, I know that is more than likely unrealistic. |
Title: Re: how to access remote x3 consol remotely? Post by dot on Jun 8th, 2009 at 3:41pm
You can use an SSH client in most recent versions of software. Telnet is inherently insecure as everything passes in clear text and thus normally disabled.
|
Title: Re: how to access remote x3 consol remotely? Post by Cheese-Hub on Jun 16th, 2009 at 4:49pm
We use SecureCRT and SSH directly into the LAN IP (not the management IP address).
One key is to have your routing set up properly. Can't figure out a way to jump out within iMonitor - I suspect because it talks to the Management IP - however there may be clever ways to route through that. |
Title: Re: how to access remote x3 consol remotely? Post by Cheese-Hub on Jun 16th, 2009 at 4:59pm
That is for iNfiniti - sorry did not make that clear. Perhaps x3 is similar.
|
Powered by YaBB 2.5.2! YaBB Forum Software © 2000-. All Rights Reserved. |