Satellite Internet forum
https://www.satsig.net/cgi-bin/yabb/YaBB.pl
VSAT technology and installation >> iDirect Forum: hubs and terminals >> 5300 mobile modem not reading correct GPS data
https://www.satsig.net/cgi-bin/yabb/YaBB.pl?num=1249376992

Message started by sridhar on Aug 4th, 2009 at 10:09am

Title: 5300 mobile modem not reading correct GPS data
Post by sridhar on Aug 4th, 2009 at 10:09am
Hi all VSAT experts
Am experiencing a problem with my mobile modem 5300. The modem is connected to GPS on console port and reads in NMEA strings and comes into network. The modem is working fine in  location 17.4 N  78.5 E and coming into network.The modem is moved to new location 18.9 N 72.8 E  , the gps is feeding in the correct lat/ long info to modem but what I observe on telnet to modem is something different 3 N 72.8 E and the modem doesn't come into network. can some one through light on this and a possible solution is  most welcome.

Title: Re: 5300 mobile modem not reading correct GPS data
Post by TDMAMike on Aug 4th, 2009 at 12:08pm
Odd.  

Falcon boots to 96008N1, what are you telling it to use for your mobile paramters?  Serial NMEA?  9600 or 4800?

I am assuming that since you were seeing the correct lat/long at the previous location that your port speeds are correct from console.  More than likely 9600 8N1.  

I would double check your configs.  Specifically what the GPS feeds the iDirect unit on console, as well as the Mobile parameters that you have configured for the iDirect unit (iBuilder Options file).  Some GPS devices have a config tool that you can use to select what NMEA strings you want to feed it, as well as what port settings you desire to use. I have found that the IDU's like 4800 8N1 better than they do 9600.  Even though that will change the port speed from the norm (read: when falcon boots it sets console to 96008N1).  

Double check everything, if you have a config tool for your GPS, you may want to consider using it.  If anything to double check things and select the strings that you want the iDirect to see on console (there are a lot of them). You may want to consider using 48008N1 and use the serial NMEA setting (either socket or ttyS0).  Experiment with both.  

Powered by YaBB 2.5.2!
YaBB Forum Software © 2000-. All Rights Reserved.