Satellite Internet forum
https://www.satsig.net/cgi-bin/yabb/YaBB.pl
VSAT technology and installation >> iDirect Forum: hubs and terminals >> Telnet iDirect Modem !
https://www.satsig.net/cgi-bin/yabb/YaBB.pl?num=1276259722

Message started by yazzdan on Jun 11th, 2010 at 1:35pm

Title: Telnet iDirect Modem !
Post by yazzdan on Jun 11th, 2010 at 1:35pm
Hello All,

I Have a question that when i telnet the iDirect modem from iMonitor ; let say i am using 192.168.1.4/30 Pool  

Modem Ip = 192.168.1.5
Router Ip = 192.168.1.6

Why the iDirect modem is not pinging the router ip from device from the iDirect modem as it is physically connected to the router ???

P.S. packets are untagged and are without VLAN.

Title: Re: Telnet iDirect Modem !
Post by fluffymassive on Jun 28th, 2010 at 3:20am
Does the router allow ping replys?
does the link on the router say UP UP?
does the modem see the link? I.e No LAN DISCONNECTED alarms?

Title: Re: Telnet iDirect Modem !
Post by 1505 on Jul 1st, 2010 at 9:19am
IP Routing OK?

Title: Re: Telnet iDirect Modem !
Post by yazzdan on Jul 2nd, 2010 at 7:33am
i Need to ping From iDirect Modem ...

Router is Up and link is working fine , all the connectivity shows by iMonitor but when i telnet the iDirect Router and ping the next device (Cisco ROuter) is not going to ping ..


Title: Re: Telnet iDirect Modem !
Post by 1505 on Jul 4th, 2010 at 8:54am
Have you tried using RIPv2 in your routing protocols?

Regards.

Powered by YaBB 2.5.2!
YaBB Forum Software © 2000-. All Rights Reserved.