Satellite Internet forum | |
https://www.satsig.net/cgi-bin/yabb/YaBB.pl
VSAT technology and installation >> LinkStar Forum: VSAT hubs and terminals >> DVBs2 terminal Help https://www.satsig.net/cgi-bin/yabb/YaBB.pl?num=1282142771 Message started by imNAK on Aug 18th, 2010 at 3:46pm |
Title: DVBs2 terminal Help Post by imNAK on Aug 18th, 2010 at 3:46pm
Dear All,
i also Install a new Ku Band Link with normal 3 W BUC and 84HH LNB and DVBs2 satellite router... from the last 10 days the link speed is very slow ( 512/256 . 10:1 ). The provider says the RX TX and Net is fine and the cables connectors , modem LNB ,BUC OMT fine ..caz i changed these things include DVBs2 but the same problem the provider change the IP but the same problem even not open yahoo.. what the problem and how can I solve the Issue. Looking for Help Noor Afghanistan Faiz Satellite Communication Kabul, Afghanistan https://www.afsat.net |
Title: Re: DVBs2 terminal Help Post by Eric Johnston on Aug 18th, 2010 at 10:16pm
If the LinkStar S2 satellite link (tx and rx quality) and modem are operating normally, test for internet network connection with single PC directly connected to the modem. Make sure that the PC has correct IP address, gateway IP address, subnet mask and DNS addresses as told to you by the service provider. IP address problems are likely to lead to complete failure to connect (no yahoo for example). First, check you can ping to the modem. If internet connection does work, but is very slow, this may be due to congestion, viruses or FAP restriction due to recent heavy downloading etc. Ask the hub and do ping tests to a hub router and so on.
Best regards, Eric |
Title: Re: DVBs2 terminal Help Post by abbas89 on Sep 1st, 2010 at 7:45pm
check BER as well very important
|
Powered by YaBB 2.5.2! YaBB Forum Software © 2000-. All Rights Reserved. |