Satellite Internet forum
https://www.satsig.net/cgi-bin/yabb/YaBB.pl
VSAT technology and installation >> HughesNet and Hughes HX VSATs >> Problem with txcode 5
https://www.satsig.net/cgi-bin/yabb/YaBB.pl?num=1291588298
Message started by Thetransponder on Dec 5th, 2010 at 10:31pm

Title: Problem with txcode 5
Post by Thetransponder on Dec 5th, 2010 at 10:31pm
When I have finished doinv pointing, and start to ranging then after some of txcode 9 appears, it change to txcode 5, and when I'm wait for a while then txcode 8 appears...but,the problem is after a few seconds txcode 5 appears again just 1 or 2 seconds...then it normal again to txcode 8, and in a few seconds it change again to txcode 5, then it normal again, it's happen continously... How to solve the problem to get txcode 5 dissapear?

I ask to noc and they said hub condition is OK, and I also have checked my cable, buc and feedhorn to...I need a suggestion

Title: Re: Problem with txcode 5
Post by James-BW on Dec 6th, 2010 at 2:11pm
Tx code 5 is normally a temporary timing issue. Please could you kindly confirm the provider you are operating with and if they have checked your ranging statistics and configuration?

Regards,

James - Bentley Walker.

Powered by YaBB 2.5.2!
YaBB Forum Software © 2000-. All Rights Reserved.