Satellite Internet forum | |
https://www.satsig.net/cgi-bin/yabb/YaBB.pl
Service Providers >> TooWay and KA-SAT satellite >> activation problem https://www.satsig.net/cgi-bin/yabb/YaBB.pl?num=1327939393 Message started by ozsuakin on Jan 30th, 2012 at 4:03pm |
Title: activation problem Post by ozsuakin on Jan 30th, 2012 at 4:03pm
hello, everybody, in the activation page, my control information as belows:
Status OK User Terminal MAC 00A0BC2643EE Forward Link SNR 8.4 dB Return Link SNR 12.2 dB Your IP address 10.167.1.207 forward link snr is red color, any problem with this? 8.4 is enough for activation? Thanks for helps... |
Title: Re: activation problem Post by creusetec on Jan 30th, 2012 at 10:48pm
If its in red its not good I would re check the dish alignment
|
Title: Re: activation problem Post by bigdishsat on Jan 30th, 2012 at 10:59pm
If the Forward Link signal is too low, the SNR figure will be displayed in Red and the page where you enter the activation code will not be displayed.
You either have very heavy rain or your dish is very slightly mis-pointed. Access your modem page (192.168.100.1) and go into install mode (/install), and tick your spot beam and click on the arrow. Your Tria should give you the 'found satellite' signal which is like a mobile phone tone ... then do the fine pointing procedure again using the elevation and azimuth adjustment bolts. Good luck. |
Title: Re: activation problem Post by ozsuakin on Feb 2nd, 2012 at 1:40pm
thanks for ur replies
|
Powered by YaBB 2.5.2! YaBB Forum Software © 2000-. All Rights Reserved. |