Satellite Internet forum | |
https://www.satsig.net/cgi-bin/yabb/YaBB.pl
VSAT technology and installation >> Hub and VSAT satellite equipment for sale and wanted >> ANDREW Elliptiguide 2132 transitions for sale https://www.satsig.net/cgi-bin/yabb/YaBB.pl?num=1534530882 Message started by Admin1 on Aug 17th, 2018 at 7:34pm |
Title: ANDREW Elliptiguide 2132 transitions for sale Post by Admin1 on Aug 17th, 2018 at 7:34pm
1st item: I have one complete NEW kit for Andrew ellipti-guide to rectangular waveguide transition. TYPE 2132DKT in box. Two castings in sealed bubble. Air port.
plus CONN HARDWARE KIT 45594-1132A Large dia O ring, short fat O ring, grease. 3 large screws and 2 small screws and allen hex key. plus Hardware kit 202853 8 screws, washers, nuts, two rectangular O rings, allen hex key. Waveguide aperture 0.75 x 0.375 inches. Flange WR75-CPRG with 8 screw holes. ----------------------------------------------------------- 2nd Item. Two main parts. Used. Andrew elliptiguide to waveguide transition to rectangular waveguide. Two castings, one with with small fat red O ring in situ. Air port. The 3 tuning screws set for minimum reflection at 14.25 GHz. Probably type 2132DCT. Sold as seen below. The 3 main screws missing. These are slightly larger diameter than regular screws. I have included 3 screws with correct thread but they are shorter than ideal and have cross head! Waveguide flange WR75 with 4 screw holes. Waveguide aperture 0.75 x 0.375 inches. If wanted, please email me eric@satsig.net All (i.e. both) to be sold in one lot. Included: Instructional sheet, mainly about carefully shaping the copper end of the elliptical waveguide. You can find similar items on ebay if you search for ANDREW COMMSCOPE TYPE 2132. |
Powered by YaBB 2.5.2! YaBB Forum Software © 2000-. All Rights Reserved. |