Satellite Internet forum | |
https://www.satsig.net/cgi-bin/yabb/YaBB.pl
VSAT technology and installation >> iDirect Forum: hubs and terminals >> burst switch problem on ULC-T line card https://www.satsig.net/cgi-bin/yabb/YaBB.pl?num=1594134465 Message started by Alec on Jul 7th, 2020 at 4:07pm |
Title: burst switch problem on ULC-T line card Post by Alec on Jul 7th, 2020 at 4:07pm
Hi everyone, we just bought an iDirect IDx 4.1.2 HUB and ULC-T and ULC-R line cards. I face a problem in bringing up carrier on ULC-T line card. when I type "tx enable" command on telnet prompt, a message "Please issue tx bs to enable burst switch" appears and we can not enable TX. Pls help solve this problem!
|
Title: Re: burst switch problem on ULC-T line card Post by Admin1 on Jul 9th, 2020 at 8:53am
I don't understand "burst switch". The spec for the iDirect ULC-T line card suggests that it only transmits one continuous carrier type DVB-S2 or DVB-S2X.
ref: ProductSheet-ULC-T.pdf If you have the manual look for an explanation of tx bs command. While testing and experimenting take care not to have the output radiating to a satellite! |
Powered by YaBB 2.5.2! YaBB Forum Software © 2000-. All Rights Reserved. |