1.8m Dish to PAS-4

(Read 2732 times)

ahmelect Senior Member ★★★ Offline Posts: 63	Jun 20^th, 2008 at 7:52pm Hi � I have a 1,8 dish want to get signal of PAS-4 sat in Iraq, I have an issue with that I havn't a satfinder or any other device to get it just have a TV satalite receiver.. any one help me please..
Back to top	« Last Edit: Jun 20^th, 2008 at 10:43pm by Admin1 » &&Ahmed&&Dar Al-Hikma YIM IP Logged

Eric Johnston

Senior Member
★★★
Offline

Posts: 2109

Reply #1 - Jun 20^th, 2008 at 10:40pm

PAS4 is same as INTELSAT 4 and is at 72 east.

Look here https://www.lyngsat.com/intel4.html for a promising TV carrier. �Consider C or Ku band and beam coverage of Iraq. �Note your LNB local oscillator frequency. � Tune your receiver.

Use https://www.satsig.net/maps/satellite-dish-pointing-iraq.htm to calculate your az, el and polarisation adjustment.

Set the nominal polarisation, then adjust the polarisation angle.

If you have a general purpose Ku band satellite TV LNBF with dual polarisation and dual Ku bands set the LNB upright and then apply the polarisation adjustment. Use the receiver controls to select vertical or horizontal (22 kHz tone) and low or hi band 9.75 or 10.6 GHz LO (13 or 19 volts DC).

Set the beam elevation angle.

Swing the dish boldly and the TV receiver should lock up.

Best regards, Eric.

IP Logged

Pages: 1

Send Topic | Print

Disclaimer, Terms of Use and Privacy Forum User Agreement Forum rules Cookie policy.