SCPC in numerous Remotes

(Read 3183 times)

smlt_vsat Senior Member ★★★ Offline Posts: 56	Oct 24^th, 2008 at 12:16pm Hi Some of remotes sites are showing scpc errors . it apperas and dissapears. What may me the possible reasons
Back to top	IP Logged

Dr_Sat Member ★★ Offline Posts: 16	Reply #1 - Oct 24^th, 2008 at 1:21pm HI, one of the main reason is bad grounding/earthing. check your Neutral -Ground voltages, should be Less than 3 volts. let me know if it helps.
Back to top	IP Logged

Ex Member Ex Member	Reply #2 - Oct 24^th, 2008 at 5:40pm Downstream SCPC errors? How many remotes are reporting errors in the entire network (example 5 of 25, etc) How errors per remote (1245 errors, etc?) ? Do the errors change remotes or are they persistent on the same remotes every time?
Back to top	IP Logged

Eric Johnston

Senior Member
★★★
Offline

Posts: 2109

Reply #3 - Oct 24^th, 2008 at 7:17pm

If you are at the hub make a list of all the sites and for each site collect the normal outlink Eb/No and BER readings.

Consider that list. �Are the sites affected by errors the ones with the lowest normal Eb/No ?. �The worst sites will be the most sensitive to local rain or to a rain fade at your hub uplink which will degrade the outlink to all sites. � �Identify the worst remote site and get it fixed. �Repeat the hit list each week or so, until you get all remote sites operating with a good rain fade margin.

If your stats show the Eb/No of a particular remote site decreasing gradually over the weeks tell them and try to resolve before failure/errors occur.

Have one remote site as a monitoring reference and closely plot its Eb/No and investigate short breaks etc which may be uplink related.

Best regards, Eric.

IP Logged

BalkanTelekom

Member
★★
Offline

Posts: 48

Reply #4 - Apr 24^th, 2009 at 11:12am

Hi,

I dont know if your problem still continues. Just a few words about scpc errors on iDirect platform:

If you see scpc errors at multiple sites in the network, then it is possibly because of downlink carrier related. Overdriven of Hub TX equipment (HPA, upnoverter i.e.) or transponder. Crosspol effect because of the other carrier(s) at the opposite pol maybe the other reason. In these cases, the modems which have lower rx snr values receive the delta scpc errors more.

Have a nice day.

Balkan Telekom http://balkantelekom.net

WWW

IP Logged