DIY installation of Ka tooway system

(Read 3517 times)

skipper

Member
★★
Offline

Posts: 2

May 30^th, 2011 at 5:34pm

Hi All,
New to this forum living in rural Spain and I'm looking for some advise on installing a Tooway Ka system? I've done TV sat. installs previously and know my way round aiming a dish, So...

Firstly where is the best place to buy the equipment from?

Next when it comes to the setup, what type of sat. finder/meter can be used? as I think the Ka band is a higher frequency than the usual sat. tv finders are capable of?

And how or must you set up a contract for the service, if so how?

Many thanks! hoping someone can point me in the right direction

IP Logged

Kevin_Jones Member ★★ Offline Posts: 11	Reply #1 - Jun 1^st, 2011 at 1:44pm hi, well the new system is good news for you as you don't need a meter. once connected to the modem the lnb (or tria) on the dish gives off a tone which increases as you lock on to the satellite. you just need to ensure you have a good line of site on a bearing of 167 degrees
Back to top	IP Logged

skipper Member ★★ Offline Posts: 2	Reply #2 - Jun 1^st, 2011 at 7:29pm That seems simple, I assume you are able to turn the tone on and off? I read somewhere that there is a way of displaying the signal spectrum on a laptop direct from the modem is this correct? Thanks for the info. Regards
Back to top	IP Logged

Pages: 1

Send Topic | Print

Disclaimer, Terms of Use and Privacy Forum User Agreement Forum rules Cookie policy.