iDirect 15100 Integrated Switch

(Read 1664 times)

Peyman Member ★★ Offline Posts: 1	Mar 6^th, 2017 at 11:29am Hello everyone, in iDirect 15100 chassis, there is an integrated 40 port Ethernet switch. is this switch configurable? Is it a layer 2 or layer 3 Device? is it Cisco-like? if this is a layer 2 switch, then which device performs routing in iDirect hub? any help and reply greatly appreciated. thank you.
Back to top	« Last Edit: Mar 6^th, 2017 at 4:55pm by Admin1 » IP Logged

Scout

Senior Member
★★★
Offline

Posts: 86

Reply #1 - Mar 31^st, 2017 at 9:44pm

Hi,
What looks like a 40 port switch on the chassis is actually a straight ethernet pass through from front to back. you cable the line cards at the front Lan A/B down to the ports below the line card slots and those are direct pass through connections to the back, there's no switch configuration capability there.

The routing on the idirect platform at the hub side is done via the upstream router and protocol processor blades.

IP Logged

Pages: 1

Send Topic | Print

Disclaimer, Terms of Use and Privacy Forum User Agreement Forum rules Cookie policy.