lat and long

(Read 5580 times)

Jul 4^th, 2005 at 11:31am

For the first time, I have to set up a linkstar with telnet.
It's all ok, but i am not able to set latitude and longitude with SAVEBOOTPARMS -lat -lon. When i control the configuration with DBPR BOOTCONF latitude and longitude are always 0.
I'm sure to insert correct value, with converting degrees minutes seconds.
Could you help me?

Apr 19^th, 2006 at 1:25pm

you need to enable the gps make this command save -m 1
then enter your lat and long

Jan 16^th, 2007 at 3:25pm

If you need to know your latitude and longitude please try this page Lat - Long Finder.

It will also tell you the azimuth, elevation and polarisation angles for your satellite dish at the same time. Select the satellite, then click progresssively on the map and magnify until you arrive at your site.

Best regards, Eric.

Email me:eric@satsig.net

Disclaimer, Terms of Use and Privacy

Old Forum rules

Cookie policy.