LinkStar Site Installation Procedure

(Read 7151 times)

Apr 24^th, 2007 at 11:58am

Hello All,

I am newly registered to this forum. I must say i am impressed with the level of resources available on this site/forum.

I am just about to start activating linkstar modems on the Mweb Platform. Can anyone help me with an itemised sequence/procedure to follow during installations of new sites.
Any other related information on site activation will be highly appreciated.

Best regards

Hammajam,
Yola.

Apr 24^th, 2007 at 12:26pm

The box for the LinkStar modem normally contains a large glossy quick reference installation guide.
See here: https://www.satsig.net/linkstar/link-star-install-glossy.pdf 693k bytes

There is a more substantial installation instructions manual available from your service provider.
See here: https://www.satsig.net/linkstar/linkstar-vsat-rcst-installation-manual-2005.pdf 1909k bytes

In both cases this may not be the latest version. Note the large file size before downloading.
wxw
Best regards, Eric.

Apr 24^th, 2007 at 3:54pm

Thank you so much for the guide Mr Eric.
I am presently going through both resources and i am finding it intresting.

Thank you so much.

Hammajam

Jun 30^th, 2009 at 10:04am

Dear Hammajam,

on our afri-sat company website we published a short step by step guide including the typical modem configuration and the typical setup process for customers:
https://www.afri-sat.com/coverage/ku_spot_is_14/get_started_is_14/

These page shows the public IP setup with the Linkstar terminal:
https://www.afri-sat.com/support/configuration/ip_setup/

This are just examples for you - but they should work with the regarding modified parameters (Frequency, Polarity, IPs etc.) with any other Linkstar broadband provider.

You will get these parameters from your ISP.

hth
good luck and
best regards,

Niels.

Email me:eric@satsig.net

Disclaimer, Terms of Use and Privacy

Old Forum rules

Cookie policy.