www.satsig.net

Satsig.net home page

Index page for all SatSig topics

SatSig Topics IndexSatellite Internet - India, Asia and Australia › DishTV India installation
SatSig topic:

DishTV India installation

(Read 7525 times)
Mar 18th, 2008 at 11:21am  
Recently I purchased DISH TV and I would like to install on my own. I realized that I need to point it to NSS6 satellite. However I would request your guidance for easy setup. Also I would appreciate if you can tell me which point in SetTop Box should be connected with antenna.

Looking for your help.

regards,
Cool Cool
Apr 1st, 2008 at 6:43pm  
good, fix ur dish to the stand then place it on a wooden board.then place the set up holding the dish so that the dish receiver faces east ,go to the back side of dist antenna ie; u r facing east and dish receiver is facing east.

Now hold the dish antenna with your both hands at each end tilt it to right about 5 degrees,no raise up/down so the degree marking below(where bolts there to fix)  is between 45 - 54 degrees.not tighten these bolts slightly .switch on the tv and STB go to set up and the to STB info press red button
here it will show channel frequencies the point it ti home tronsponder then increase the volume to 50 or 60 u sholud be hearing beep like tiet tiet or tttit ttit . now again go to ur dish slightly tilt is move it up and down at some point u will here a high continous beep like ttttttttttttttttttttttttttttttttttttttttttttttit ttttttttttttttttttttttttttttttttttttttit tttttttttttttttttttttttttttttttttttttttttttttttit . fix it here u will get the channels once u search.thats it its simple ............

u can call me at 998667216 or mail me at sudheer316@gmail.com if u have doubts

www.satsig.net

Email me:eric@satsig.net

Disclaimer, Terms of Use and Privacy

Old Forum rules

Cookie policy.