how do i log in to a gilat 360e modem and setup

(Read 6244 times)

Mar 25^th, 2008 at 9:24pm

Can any one tell me how do i log in to a gilat skystar 360e modem? also should it set up dhcp or is it static ip if so what settings do i enter in network settings i am using windows vista,

Also does any one have any setup software or user guide for this modem

Mar 26^th, 2008 at 6:18pm

There is new 1.8m C-band and new 1.2m Ku-band dish with iDirect in my stock. And used 3.8m if u care for any call +2348032087234.

Jun 15^th, 2008 at 1:32am

The 360 is not self-hosted. To set it up and to use it, you will need to have software running on your computer. To my knowledge, that software is not compatible with Vista.

I am in the U.S. and they will no longer commission the 360 modems here. There is no support for the software on Vista here. Maybe you'll get a response from Europe that is different.

Jun 15^th, 2008 at 7:17am

Software on the PC is not needed, no fixed IPs needed, just a bit of software for the inital setup and configuration of USB port.
The only variation I can tell to this is 360 modems in Germany were upgraded by Satlynx to the 360E firmware standard.
This to my knowlege is not done anymore by Satlynx

Jun 30^th, 2009 at 7:39pm

When you get into the modem there are a ton of parameters that the hub will have to provide you. With regards to DHCP and Static, that is set at the hub.

Email me:eric@satsig.net

Disclaimer, Terms of Use and Privacy

Old Forum rules

Cookie policy.