how to access remote x3 consol remotely?

(Read 2522 times)

May 24^th, 2009 at 12:27pm

hello guys again

as i know console connection to idirect modem need physical connection through lan port isthat right?

can i establish console connection (idirect linux kernel) remotely?

May 24^th, 2009 at 1:56pm

Although I am not 100% certain, I think you must have a physical connection to that console interface.

Most Hub Operators/Owners use a Console Server, such as a Comtrol Device master RTS, etc to get at the console port remotely (line cards, etc). For a remote user, I know that is more than likely unrealistic.

Jun 8^th, 2009 at 3:41pm

You can use an SSH client in most recent versions of software. Telnet is inherently insecure as everything passes in clear text and thus normally disabled.

Jun 16^th, 2009 at 4:49pm

We use SecureCRT and SSH directly into the LAN IP (not the management IP address).

One key is to have your routing set up properly.

Can't figure out a way to jump out within iMonitor - I suspect because it talks to the Management IP - however there may be clever ways to route through that.

Jun 16^th, 2009 at 4:59pm

That is for iNfiniti - sorry did not make that clear. Perhaps x3 is similar.

Email me:eric@satsig.net

Disclaimer, Terms of Use and Privacy

Old Forum rules

Cookie policy.