|
|
| SatSig Topics Index › HughesNet and Hughes HX VSATs › TCP Acceleration issues |
SatSig topic: TCP Acceleration issues(Read 4329 times) |
|
Oct 5th, 2009 at 3:43pm
The weather has been decent for the last week...only a bit cloudy at times with little to no wind. The dish sits atop a 2-story building which is VERY difficult to access without a 20ft extension ladder or a scissor lift. I went up there today, confirmed everything was connected properly and that all the bolts were tightened. Modem has not fluctuated from the 90-91 percent signal the entire time. I don't know what caused the internet to suddenly crash. I have not changed anything and in need of immediate assistance. My POL right now is around 51 (48 is the prescribed POL +3.5 for Eutelsat). Unfortunately, it is quite difficult to phone BW from atop the building, so as much info as possible via forum is requested. I will try and take pictures tomorrow morning if it will help. |
|
Oct 5th, 2009 at 5:23pm
The site should be fine now , you can contact on MSN no need to phone we have live 1-1 interactive support 7 days a week on MSN messenger and all the support engineers contact information has beeen sent to you , please get back to me if you have any more issues anthony@bentleywalker.com Good Afternoon Sir, A colleague of mine came across your update on the forum today and requested that I look into your case immediately. I have located the cause of your recent troubles, it would appear that the profile loaded to the modem had become corrupted, I have reloaded the profile and software remotely which has cured the problem. I have also re-ranged your site to ensure that the transmit power values are fully optimized to ensure you get the best out of the system. Also; to address your concerns about support, we are available via msn/yahoo instant messengers, email, tickets and telephones. I have attached our master contact sheet which contains all methods of contact for all operators within all departments of Bentley Walker Ltd. If you wish you can treat me as your primary contact for support, however; I would always recommend CC’ing support@bentleywalker.com to all email correspondence as this email address is picked up by all of my colleagues in technical support. Best Regards, Gary Delaney Tech Support Team Tel: +44 (0) 23 9231 1118 Fax: +44 (0) 23 9246 1465 Web: www.bentleywalker.com Email: gary@bentleywalker.com MSN: gary_del@hotmail.com |
|
Nov 14th, 2009 at 8:52pm
Please ALWAYS contact us we are your service provider and we have live interactive support 7 days a week,there has been some interference on W6 caused by an uplink in Dubai emitting cross pol, it has been eradicated now, there was an outage Wednesday evening for around 2 hours but and it reoccured today but its now been taken care of see below, anyhow my team will be in touch with you tomorrow, do you have access to our ticket system ? Can you please try this ...go to the web interface 192.168.0.1. go to the blue small man and click on him then you will see installation then force range, please do that and give us feedback if the system is OK or not. Further more your system is covered by a Service Level agreement if you have a loss of service we will compensate you, I will have accounts credit you 1 week on next period of subscription, in meantime please make sure you give us feedback directly rather than posting on the forum as we will be able to guide you correctly as its our Hughes HX 50 Network Best Regards A Walker CEO Bentley Walker Ltd Dear Distributor, Please be informed that the interference has been identified, at the moment all service is running properly. Best regards, Skylogic NOC Team Skylogic S.p.A Unipersonale Via Centallo, 72 10156 Torino, Italy www.skylogic.com |
|
Email me:eric@satsig.net |