GRE Tunnels

(Read 4808 times)

Jan 20^th, 2010 at 8:29am

Dear All,
how can i establish GRE tunneling in remote 3100.

i need the procedure sets up the GRE tunnel within the iDS system.
how can i establish the actual GRE endpoints on both
sides of the link for a GRE tunnel to work.

how can i configure upstream from the Protocol Processor and downstream from the remote

Jan 20^th, 2010 at 11:27am

Talk to your hub operator.

Jan 20^th, 2010 at 2:39pm

Just i want now wich ip will the hub getway.

Jan 20^th, 2010 at 3:05pm

The iDirect equipment is GRE-aware. You need to create your GRE tunnel between a Cisco router or other device at the remote site and a device at the datacenter or near the hub. You then configure the IP addresses of these two end points of the tunnel in iBuilder. The iDirect platform will then accelerate all the traffic within this tunnel. The iDirect equipment cannot create or terminate a GRE tunnel. For more info read the iBuilder User Guide.

Email me:eric@satsig.net

Disclaimer, Terms of Use and Privacy

Old Forum rules

Cookie policy.