iscpc route configuration on idirect 5100

(Read 4613 times)

Aug 27^th, 2011 at 6:29am

Hello

Need some help in configuring packet routing between two remotes 5100 idirect modem. My ip plan is as follows:

remote A

sat0: 192.168.0.1/24
eth0:10.0.0.1/24

remote B:

sat0: 192.168.0.2/24
eth0: 10.0.1.1/24

both sites have lock on the modem. I just need to start communication between them.

regards

Sep 21^st, 2011 at 1:59am

Hi Aniams,

is it not connect to internet ? only 2 remote communication?

if not then you can configure the routing from iSite.
click edit, then add "static routes"

from remote A :
IP address : 10.0.1.0
subnet : 255.255.255.0
gateway : 192.168.0.2
interface : sat0

from remote B :
IP address : 10.0.0.0
subnet : 255.255.255.0
gateway : 192.168.0.1
interface sat0

in case if you connect to internet you need to modify the routes table.

Oct 12^th, 2011 at 7:45am

another vaild way also is to enable RIPv2 on both interfaces (for both modems) from iSite without defining static routes but for sure this for LAN to LAN communication but when it comes to internet connectivity insertion of puplic IPs or NAT may be imperative.

Oct 12^th, 2011 at 7:51am

With regard to the same topic, any idea about the typical QoS configuration for both ends of the link. Kindly elaborate.

Email me:eric@satsig.net

Disclaimer, Terms of Use and Privacy

Old Forum rules

Cookie policy.