SatSig topic:

activation problem

(Read 7042 times)

Jan 30^th, 2012 at 4:03pm

hello, everybody, in the activation page, my control information as belows:

Status OK
User Terminal MAC 00A0BC2643EE
Forward Link SNR 8.4 dB
Return Link SNR 12.2 dB
Your IP address 10.167.1.207

forward link snr is red color, any problem with this? 8.4 is enough for activation?

Thanks for helps...

Jan 30^th, 2012 at 10:48pm

If its in red its not good I would re check the dish alignment

Jan 30^th, 2012 at 10:59pm

If the Forward Link signal is too low, the SNR figure will be displayed in Red and the page where you enter the activation code will not be displayed.

You either have very heavy rain or your dish is very slightly mis-pointed. Access your modem page (192.168.100.1) and go into install mode (/install), and tick your spot beam and click on the arrow.

Your Tria should give you the 'found satellite' signal which is like a mobile phone tone ... then do the fine pointing procedure again using the elevation and azimuth adjustment bolts.

Good luck.

Feb 2^nd, 2012 at 1:40pm

thanks for ur replies