SatSig topic:

iDirect iQ desktop

(Read 3240 times)

Sep 20^th, 2022 at 8:02am

Hello

im from indonesia , sorry if my english is bad

anyone know,how to stop service falcon on iQ desktop , i wanna try to recovery this modem .. i wanna recovery like idirect X3 way

big many thanks for advice

Sep 22^nd, 2022 at 7:04am

You mean to reset factory default ?

or if you mean to enter falcon recovery mode with CLI .. as I know that not support in idirect iQ-Series remotes

regards

Sep 24^th, 2022 at 2:37pm

not to reset factory default , if just reset i was did it
i wanna put some files on /sbin, /var or other
coz my idirect iQ desktop was kernel panic /sbin was lost
and some partition tmpfs was lost like active0 or factory
i was just trying using this command

console=ttyS0,115200n8 init=/bin/sh debug,earlyprintk=serial,ttyS0,115200n8,keep partition=factory maxcpus=4 finalcpus=4 isolcpus=1-3

but not working

thanks

Jul 13^th, 2023 at 1:26am

Did you try connect with uart port from iQ remote? you can use putty (serial port) to connect console and have access linux folders.

Set the putty serial port with
Speed baud 115200 bauds,
Data bits 8,
Stop bits 1,
Parity None,
Flow Control XON/XOFF.

Once the serial connection has been established towards the iQ remote, you could easily retrieve its LAN IPv4 address by connecting to the Linux operative system and, from there, entering the €œifconfig€ command you can fix the ip to access and reinstall de image from iDirect by web browser as indicated in the installation manual.

iq- linuxlogin: rootPassword: iDirect[root@iq-linux:active0:~] > ifconfig

eth1 Factory Management IP address.
eth1.1 User defined LAN IP address (admin VLAN)