GRE Tunnels

(Read 4741 times)

Ex Member Ex Member	Jan 20^th, 2010 at 8:29am Dear All, how can i establish GRE tunneling in remote 3100. i need the procedure sets up the GRE tunnel within the iDS system. how can i establish the actual GRE endpoints on both sides of the link for a GRE tunnel to work. how can i configure upstream from the Protocol Processor and downstream from the remote
Back to top	IP Logged

Ex Member Ex Member	Reply #1 - Jan 20^th, 2010 at 11:27am Talk to your hub operator. �
Back to top	« Last Edit: Jan 21^st, 2010 at 2:44am by N/A » IP Logged

Ex Member Ex Member	Reply #2 - Jan 20^th, 2010 at 2:39pm Just i want now wich ip will the hub getway.
Back to top	IP Logged

dot

Senior Member
★★★
Offline

Posts: 118

Reply #3 - Jan 20^th, 2010 at 3:05pm

The iDirect equipment is GRE-aware. You need to create your GRE tunnel between a Cisco router or other device at the remote site and a device at the datacenter or near the hub. You then configure the IP addresses of these two end points of the tunnel in iBuilder. The iDirect platform will then accelerate all the traffic within this tunnel. The iDirect equipment cannot create or terminate a GRE tunnel. For more info read the iBuilder User Guide.

IP Logged

Pages: 1

Send Topic | Print

Disclaimer, Terms of Use and Privacy Forum User Agreement Forum rules Cookie policy.