Advertisment: Broadband via satellite
Advertisment: Worldwide satellite services from Ground Control Company

www.satsig.net

Satellite Internet Forum.

Welcome, Guest.        Forum rules.
      Home            Login            Register          
Pages: 1

How To Setup Time & Date for HX50 & vxwork?

(Read 2801 times)
punkq
Member
★★
Offline



Posts: 2
Apr 12th, 2011 at 8:00am  
Dear All,
How to set up the date in the system HX50? (from SCC, General --> More --> STU Show)

& what the default user login & pass for HX-50 vxworks ?

Thank you

www.satkomindo.com
Back to top
 
WWW | YIM  
IP Logged
 
USN - Retired
YaBB Moderator
★★★★★
Offline



Posts: 837
Kentucky (USA)
Reply #1 - Apr 12th, 2011 at 1:15pm  
I have the HN7000, but the GUI is almost identical to that of the HX50. Given that modem sync is dependent upon network timing, the time displayed by the modem is obtained over the satellite from the NOC. No user input.

Nor do I have any input capability to define a user log-in/password. As you seem already to have discovered, all that's required is to direct a browser to the LAN1 IP address. In my case 192.168.0.1 gets me to the top level menu. You then drill down from there, most often to https://192.168.0.1/fs/advanced/advanced.html

If the HX50 does in fact have the capabilities about which you enquire, I apologize in advance.

//greg//
Back to top
 

USN (Ret)
 
IP Logged
 
Pages: 1