Amazon Advertisment: Satellite phone for sale
Amazon Advertisment: Starlink broadband terminal for Sale

www.satsig.net

Satellite Internet Forum.

Welcome, Guest.        Forum rules.

To search this site click here >  SATSIG search

      Home            Login            Register          
  Satellite Internet forum › iDirect Forum: hubs and terminals › X1 Modem: No Transmitt CW
Pages: 1

X1 Modem: No Transmitt CW

(Read 2818 times)
Ex Member
Ex Member
Apr 10th, 2014 at 4:10am  
I found no transmit CW of the X1.
I use 3.7 M antenna and BUC 2 Watt.
Beforehand, I had already checked the transmit CW using a spectrum analyser and it did appear.
I also had already tried to add the X1 remote (in iBuilder) but it couldn’t join in whereas I had set the configuration as same as the other existing X1 remote.
Please help me  Undecided 
Back to top
 
 
IP Logged
 
fluffymassive
Senior Member
★★★
Offline



Posts: 67
SA. Australia
Reply #1 - Apr 10th, 2014 at 8:25am  
Hi,
When you said you checked the CW with the spec an, how did you do this?

Did you connect the Spec an directly to the transmit port of the modem?

I have not used that many X1 modems, but from what I can understand below the remote is not coming into the network. Have you tried to check your CW carrier with the satellite operator? If you can not see the CW, go and check to make sure that there is DC on the tx cable, make sure the cables are connected properly and confirm BUC LO is correct.

If you can see the CW, and it is just not acquiring into the network, get the network operator to see if that are seeing bursts from the modem, also to make sure that it is activated, and the BUC is the correct size for your inroute/footprint.

Good luck.
Back to top
 
 
IP Logged
 
Ex Member
Ex Member
Reply #2 - Apr 10th, 2014 at 9:21am  
First, thanks a lot for the reply.

When I used an spectrum analyser to see the transmit CW and I had found it.
But when I had ever tried connecting the X1 to BUC 2 watt (using antenna 3.7 m), the Satellite Operator confirmed me that they found no transmit CW on frequency I had set. I had ever tried to replace the antenna with the smaller size, replacing the cable, and also replacing the BUC with 3 watt and 5 Watt, but it's not working.
I also try to configure the remote as same as the other remote using X1, in iBuilder, but the remote can't be applied; can't join tothe network.
Is the X1 broken?  Sad
Back to top
 
 
IP Logged
 
Pages: 1

Email me: eric@satsig.net

Powered by YaBB 2.5.2!
YaBB Forum Software © 2000-. All Rights Reserved.

Disclaimer, Terms of Use and Privacy   Forum User Agreement   Forum rules   Cookie policy.