Advertisment: Broadband via satellite
Advertisment: Worldwide satellite services from Ground Control Company

www.satsig.net

Satellite Internet Forum.

Welcome, Guest.        Forum rules.
      Home            Login            Register          
  Satellite Internet forum › iDirect Forum: hubs and terminals › iDirect iQ desktop
Pages: 1

iDirect iQ desktop

(Read 1731 times)
Frezz
Member
★★
Offline



Posts: 2
Sep 20th, 2022 at 8:02am  
Hello

im from indonesia , sorry if my english is bad

anyone know,how to stop service falcon on iQ desktop , i wanna try to recovery this modem .. i wanna recovery like idirect X3 way

big many thanks for advice
Back to top
 
 
IP Logged
 
kozip
Member
★★
Offline



Posts: 2
Reply #1 - Sep 22nd, 2022 at 7:04am  
You mean to reset factory default ?

or if you mean to enter falcon recovery mode with CLI .. as I know that not support in idirect iQ-Series remotes

regards
Back to top
« Last Edit: Sep 22nd, 2022 at 8:39am by kozip »  
 
IP Logged
 
Frezz
Member
★★
Offline



Posts: 2
Reply #2 - Sep 24th, 2022 at 2:37pm  
not to reset factory default , if just reset i was did it
i wanna put some files on /sbin, /var or other
coz my idirect iQ desktop was kernel panic /sbin was lost
and some partition tmpfs was lost like active0 or factory
i was just trying using this command

console=ttyS0,115200n8 init=/bin/sh debug,earlyprintk=serial,ttyS0,115200n8,keep partition=factory maxcpus=4 finalcpus=4 isolcpus=1-3

but not working



thanks
Back to top
 
 
IP Logged
 
Fernando
Member
★★
Offline



Posts: 4
Reply #3 - Jul 13th, 2023 at 1:26am  
Did you try connect with uart port from iQ remote?  you can use putty (serial port) to connect console and have access linux folders.

Set the putty serial port with 
Speed baud 115200 bauds,
Data bits 8,
Stop bits 1,
Parity None,
Flow Control XON/XOFF.


Once the serial connection has been established towards the iQ remote, you could easily retrieve its LAN IPv4 address by connecting to the Linux operative system and, from there, entering the “ifconfig” command you can fix the ip to access and reinstall de image from iDirect by web browser as indicated in the installation manual.

iq-  linuxlogin: rootPassword: iDirect[root@iq-linux:active0:~] > ifconfig

eth1       Factory Management IP address.
eth1.1    User defined LAN IP address (admin VLAN)
Back to top
 
 
IP Logged
 
Pages: 1

Email me: eric@satsig.net

Powered by YaBB 2.5.2!
YaBB Forum Software © 2000-. All Rights Reserved.

Disclaimer, Terms of Use and Privacy   Forum User Agreement   Forum rules   Cookie policy.